Composition
Polyarylalkylphenol polyethylene glycol ether phopho-
ric acid ester

Product properties *)

Active substance content
about 96 % in water

Ionicity
anionic

Appearance at 25°C
brownish, viscous liquid

pH value (DIN 53996) , 5% in water at 50°C
approx. 2

Solubility at 25 °C
soluble in water

Density at 25 °C
approx. 1.13 g/cm³
Flash point (DIN/ISO 2592)
> 100 °C

Biocides
free of any additional biocide

Use
Dispersing agent LFH is an anionic AP-free dispersing
agent and used for water based, solvent based of water /
solvent based pigment preparations, pastes, printing
inks and coatings.

Dispersing agent LFH is suitable for inorganic pig-
ments (metal oxids), carbon black and specially for
organic pigments (polycylcic and phthalocyanine pig-
ments) that are difficult to disperse.

The advantages of Dispersing agent LFH are

-high pigment concentration
-low viscosity of the preparation
-high stability of the preparation in a wide tem-
 perature range
-low foaming.
 
General recommendation of dosage:

1 - 6 % on inorganic pigments and fillers
4 - 20 % on organic pigments.

This information is based on our present state of knowledge and is intended to provide general notes on our products and their uses. It should not therefore be construed as guaranteeing specific properties of the products described on their suitability for a particular application. Any existing industrial property rights must be observed. The quality of our products is guaranteed under our General Conditions of Sale.
*) These characteristics are for guidance only and are not to be taken as product specifications. The tolerances are given in the product specification sheet. For further information on product properties, toxicological, ecological and safety data, please refer to the safety data sheet.